Cisco Switches Business Computer Network Questions Help Answer the one question from each assigned section this week (sections 6.1-6.6). Each response should be 1-2 paragraphs in length. Type your numbered answers in a Word document (i.e. Section 6.1 Question 2, etc.). APA formatting is not required. If you use outside sources to support your answers, provide APA-style citations and a reference page.
Answer one of the following from Section 6.1:
What are the requirements for connecting a VTY (virtual terminal) to a Cisco device?
What types of cable can you use to connect a PC to a router console port?
What is the difference between a managed and unmanaged switch?
What is the difference between in-band and out-of-band management?
Answer one of the following from Section 6.2:
Why would you configure an IP address on a switch?
What does the ip address dhcp command allow you to do?
Answer one of the following from Section 6.3:
How does the VLAN interface configuration mode differ from Ethernet, FastEthernet and GigabitEthernet interface configuration modes?
What must you consider if you manually configure the speed or duplex setting?
What happens when autonegotiation fails for the Ethernet interface on a Cisco device?
What is the default setting all ports on a switch?
Answer one of the following from Section 6.4:
What are two advantages to creating VLANs on your network?
You have two VLANs configured on a single switch. How many broadcast domains are there?
How many collision domains are there?
What happens if two devices on the same switch are assigned to different VLANs?
Answer one of the following from Section 6.5:
What is trunking?
Why is trunking important to VLAN configuration?
What protocol does a Cisco switch use to automatically detect trunk ports?
By default, traffic from which VLANs are allowed on trunk ports?
What is the default configuration of most Cisco switches?
Answer one of the following from Section 6.6:
Why will a tie breaker never be necessary for the root switch selection?
When would you modify an STP mode?
How does PVST+ differ from Rapid PVST+?
How do ports work in a multiple VLAN environment?
How are root bridges designated in a multiple VLAN environment?
What happens during STP convergence?
LDR 3302-21.01.01-1A24-S1, Organizational Theory and Behavior Unit III Essay Top of Form Bottom of Form…
Chapter 9 What are teratogens? Give 5 examples. Define each of these stages: Germinal, embryonic,…
You are a Financial Analyst that has been appointed to lead a team in the…
You are familiar with the ANA Code of Ethics and have a growing understanding of…
This week’s discussion will focus on management decision-making and control in two companies, American corporation…
Mary Rowlandson felt that the man who eventually came to own her, Quinnapin, was “the…